Allworx 9212 Bedienungsanleitung PDF herunterladen (Seite 26)

Phone Guide – 9212

7.7 Check the Network Settings

Warning: Do not make any changes to your network settings unless instructed by your System

Administrator.

1. Select the CONFIG soft key.

2. Scroll down and highlight Network Settings.

3. Press the Select button

DHCP – Allows the phone to extract its configuration from the server.

i. Enabled (Default)

ii. Disabled

VLAN – Allows the phone to stay on the same network without any hardware reconfiguration.

i. Enabled

ii. Hub Debug Mode

iii. Disabled (Default)

Remote Plug ‘n’ Play – Key used to set up a remote phone. See the System Administrator.

Edit Time Server IP – Option to change the Time Server the phone is logged into.

Edit Boot Server IP – The WAN IP address the server is using for the setup of a remote phone.

Edit Phone IP – Option will appear if DHCP is disabled. Allows the manual entry of the phone’s

IP.

Edit Netmask IP – Option will appear if DHCP is disabled. Allows the manual entry of the

Netmask IP.

Edit Gateway IP – Option will appear if DHCP is disabled. Allows the manual entry of the

Gateway IP.

Phone VLAN Settings – Option will appear if VLAN is enabled.

i. Enter VLAN ID – 2 (Default)

ii. Enter VLAN Priority – 7 (Default)

PC VLAN Settings – Option will appear if VLAN is enabled.

i. Enter VLAN ID – 1 (Default)

ii. Enter VLAN Priority – 0 (Default)

4. Select the EXIT soft key.

5. Select the YES soft key to save any changes OR select NO to cancel changes made.

7.8 Current Status / Info

1. Select the CONFIG soft key.

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

Revised: May 28, 2008

Page 22

1 2 ... 21 22 23 24 25 26 27 28 29 30

Keine Kommentare

Allworx 9212 Bedienungsanleitung Seite 26